Waterco Pump Supatuf ECO Variable Speed

It’s quality that makes Waterco one of Australia's leading manufacturers of quality swimming pool and spa products. Waterco has a long standing reputation for the best-quality equipment for domestic swimming pools and spas at competitive prices.

There is no substitute for any of the essential elements that ensure durability, quality and dependability within the Waterco range of equipment, parts and accessories. Delivering performance, efficiency and quiet operation in every facet of the Waterco product. If you fit inferior, non-genuine equipment and parts, you might save money in the short term – but you’re risking damaging the efficiency, reliability and long-life of your Waterco pool equipment.

Features:

• Variable 3 speed control panel, IP55 rating
• Permanent magnet brushless
• Variable 3 speed DC motor
• UV stabilised & corrosion resistant
• 50mm quick connect barrel unions for UPVC pipe
• Clear basket lid & large strainer basket
• High grade carbon/ graphite mechanical seal with 316 stainless steel spring assembly
• Strong single piece glass filled thermoplastic pump body
• Hydraulically efficient impeller and diffuser design
• Fan cooled thermal overload protection

Benefits:

• Energy saving variable speed motor
• Low noise operation
• Energy rating 7 stars
• Variable permanent magnet brushless DC motor
• 2 Year warranty

Quick Pool Pump Installation Guide:

Installing a pool pump is as simple as swapping out your old pump to a new one. But if the new one isn’t designed to retrofit with your current pump, then don’t worry too much, with some basic tools and some elbow grease, you’ll have your new pump installed in no time. 

• Turn off the power to your pool equipment at the mains and switch off any valves leading to and from the pump to give you a splash free-environment while you work. 
• Detach the pump from the power supply and unscrew the unions. 
• Note: If you have an older pump that’s hard plumbed into your system then you may have to saw off the current pipes. Cut as close to the pump as possible. If this is the case then now might be a good time to install unions. 
• Remove the pump and set aside. Position new pump on where the old pump previously was and assess what kind of plumbing needs to be done. It should be as simple as mounting the pump properly and screwing in unions. But if not, do the necessary plumbing work and connect your pump. 
• Once the pump is plumbed in, open up all the valves and connect the power. 
• Turn on the pump to see if the pump is working. Check for any leaks and that’s it!